[DeTomaso] heater valve

[John Buckman]

That is the later style valve, which is different.

John



On May 20, 2013, at 12:13 PM, Ken Green wrote:

> This may be helpful:
>  
> http://www.panteraplace.com/page180.htm
>  
>  
> 
> From: John Buckman <jb841 at cox.net>
> To: detomaso at poca.com 
> Sent: Monday, May 20, 2013 11:29 AM
> Subject: Re: [DeTomaso] heater valve
> 
> I found the post on the PI forum.  You need to be logged in to see the pics.  
> 
> Basically, you disassemble the valve and thread the packing end of the valve body with a 3/8"-24 die.  Purchase 
> a 3/16" (NOT 1/8" as stated in the PI forum post) compression fitting and some teflon valve packing material at 
> your favorite DIY store.  You will only need the nut from the compression fitting.  Assemble the valve stem, 
> compression nut and packing, and reassemble the valve.
> 
> John 
> _______________________________________________
> 
> Detomaso Forum Managed by POCA
> 
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso
> 
>