[DeTomaso] Engine Break In - Oil Pump Prime
Julian Kift
julian_kift at hotmail.com
Fri Feb 1 23:56:00 EST 2013
If you didn't prefill the filter with oil then you'll be filling that first.
Julian
> From: seanmundy at hotmail.com
> Date: Fri, 1 Feb 2013 20:48:59 -0800
> To: chance.dorsey at yahoo.com
> CC: detomaso at poca.com
> Subject: Re: [DeTomaso] Engine Break In - Oil Pump Prime
>
> I guess I need to be patient and let the drill do the spinning. I will try tomorrow and let you know. Thanks!!!
>
> Sent from my iPhone
>
> On Feb 1, 2013, at 8:32 PM, Chance Dorsey <chance.dorsey at yahoo.com> wrote:
>
> > CCW is the correct way.
> >
> > I also rotated the crank two full turns (From TDC 1 to TDC 1) while I was running the drill.
> >
> > Thanks,
> >
> > Chance Dorsey
> > Austin, TX
> >
> > On Feb 1, 2013, at 8:50 PM, sean mundy <seanmundy at hotmail.com> wrote:
> >
> >>
> >> I've finally got my ZF and new engine back in my car and getting closer to first startup.
> >> After filling up with oil I am trying to spin the oil pump to prime the engine but I'm not seeing results.
> >> I have spun my drill in reverse and clockwise for over a minute each way but no oil has yet emerged
> >> from the rockers and into the top of the heads. The drill has way more drag in the reverse direction but nothing
> >> is happening. Do I got this right? Thanks, Sean
> >> _______________________________________________
> >>
> >> Detomaso Forum Managed by POCA
> >>
> >> DeTomaso mailing list
> >> DeTomaso at poca.com
> >> http://poca.com/mailman/listinfo/detomaso
> >
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list