[DeTomaso] Slave Cylinder
Mike Drew
MikeLDrew at aol.com
Sat Apr 27 09:17:25 EDT 2013
Freddy,
You don't mention if this noise you are hearing is only with the engine running, but if so, then the sound you hear is probably your clutch throw out bearing. Replacing it isn't too hard but it does require you to pull the gearbox out. Do you know if the clutch has ever been replaced? If the clutch is original it makes sense to change it at the same time, but if it has been replaced recently (or at least you know it has low miles) then you can just inspect it and re-install it
Mike
Sent from my iPhone
On Apr 26, 2013, at 15:24, "Freddy Henningsen" <fredhen at online.no> wrote:
> when my slave cylinder was ugly and oxidized, I bought a new standard from
> hal.
> I adjusted the length of the rod too the same length as the old one was.
> but when I press the clutch pedal .I get one bad sound. sounds like the
> bearing sharp in the clutch.
> but with the pedal out, there is no sound. everything sounds good.
> Are there some of you who have experienced this? and possibly have any idea
> what this could be and how I can fix this?
>
> sorry for my bad,bad english;)
>
> Freddy
> 7207
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list