[DeTomaso] Inner front wheel bearing to sprindle fit?
MikeLDrew at aol.com
MikeLDrew at aol.com
Wed Sep 26 12:01:24 EDT 2012
In a message dated 9/26/12 8 45 30, kenn_green at yahoo.com writes:
> I tried to push one of the new wheel bearings onto the spindle, but it
> won't slide into position. I don't want to force it because I'm not sure how
> hard it would be to get it off, especially when it's under the seal in the
> hub. Someone suggested polishing the spindle surface, any suggestions on
> this, or how to polish it?
>
>>>And Larry steps up to the plate....:>)
Mike
More information about the DeTomaso
mailing list