[DeTomaso] Inner front wheel bearing to sprindle fit?
Will Kooiman
will.kooiman at gmail.com
Wed Sep 26 12:30:33 EDT 2012
I cleaned it really well and then some light sanding with emery cloth. Like polishing shoes.
Sent from my iPhone
On Sep 26, 2012, at 12:01 PM, MikeLDrew at aol.com wrote:
>
> In a message dated 9/26/12 8 45 30, kenn_green at yahoo.com writes:
>
>
>> I tried to push one of the new wheel bearings onto the spindle, but it
>> won't slide into position. I don't want to force it because I'm not sure how
>> hard it would be to get it off, especially when it's under the seal in the
>> hub. Someone suggested polishing the spindle surface, any suggestions on
>> this, or how to polish it?
>
>>>> And Larry steps up to the plate....:>)
>
> Mike
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list