[DeTomaso] ZF ACORN NUTS
Rob Dumoulin
rob at dumoulins.net
Tue Jul 19 13:44:13 EDT 2011
How about a nice stainless Steel washer?
On Tue, Jul 19, 2011 at 1:06 PM, <mikeldrew at aol.com> wrote:
> Bob wrote:
>
>
> Not knowing.....my restoration shop installed the acorn
> uts and when the nut bottomed out they just tightened away pushing the
> stud
> nto the ZF REAR casing. I backed out the stud located at 10:30 and put the
> riginal nut in place and then covered it with the acorn nut.
>
>
>
>
> >>>Glad you found the source of the problem, but now your sealing acorn
> nut, isn't.
>
> What you need to do is use a cutoff wheel to shorten the protruding end of
> the stud, so that the acorn nut will bottom out on the surface of the rear
> cover. I had to shorten 3-4 of my studs when I switched to sealing acorn
> nuts. No more leaks!
>
> Mike
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
--
Rob DuMoulin
904.476.8744
rob at dumoulins.net
More information about the DeTomaso
mailing list