[DeTomaso] Pulling Valve Covers to Replace Gaskets
MikeLDrew at aol.com
MikeLDrew at aol.com
Fri Apr 22 18:04:51 EDT 2011
In a message dated 4/22/11 13 11 22, eanderson at geotracinternational.com
writes:
> Any recommendations for pulling the valve covers and removing the
> existing (cork) gaskets with minimal mess?
>
Hopefully you glued your gaskets to the inside of the valve covers, and put
a light coating of grease between the gasket and the surface of the head?
That lets them just lift right off.
If they stick to the head, prepare to have fun with your gasket scraper. :<
(
If they stick to the valve cover, you still get to have fun with your
gasket scraper, but at least it doesn't fall into the motor.
Mike
More information about the DeTomaso
mailing list