[DeTomaso] Axle nut chamfer question
John Buckman
jb841 at cox.net
Sun Aug 8 21:56:48 EDT 2010
Julian,
We just had a discussion about this on the PI forum. The taper goes towards the nut.
Second, third, and fourth post from the bottom.
http://pantera.infopop.cc/eve/forums/a/tpc/f/1510042044/m/812107194/p/10
John
On Aug 8, 2010, at 6:17 PM, Julian Kift wrote:
>
> Today I went through the usual checks on the GT5 in preparaton for the trip to Monterey; firstly I find a screw in a rear tire, so need to get that repaired (or new tires) then to top that I find have a bad rear axle yet again (less than 2 thousand miles on the previous vendor rebuild). These are the later stepped axle design that seem to be like gold dust or ounce for ounce at least as valuable......
>
> I know the question has cropped up before, but is the axle nut chamfer supposed to be face down or face out. I had always assumed chamfer out i.e. flat face to the axle, but it turns out I have one of each on axles assembled by the same vendor?
>
> Thanks
> Julian
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list