[DeTomaso] Gauge panel question
Dagny Kristine Bakken
dagny-kr at online.no
Sat Feb 21 16:50:41 EST 2009
_____
Fra: Dagny Kristine Bakken [mailto:dagny-kr at online.no]
Sendt: 21. februar 2009 22:49
Til: 'MikeLDrew at aol.com'
Emne: SV: [DeTomaso] Gauge panel question
Yes of course, it must have been cheaper to produce the one pice plastic
unit,instead of the two piece metal one.And in addition this one is also
fastened with some special knuled head screws not cheap,whereas the later
has more common types.Definitively both weight and cost savings :)
Øyvind
_____
Fra: MikeLDrew at aol.com [mailto:MikeLDrew at aol.com]
Sendt: 21. februar 2009 22:36
Til: dagny-kr at online.no; detomaso at realbig.com
Emne: Re: [DeTomaso] Gauge panel question
In a message dated 2/21/09 13 25 8, dagny-kr at online.no writes:
Our #2293 with two pod dash has the metal panel covered with naugahyde and
#6383 with single pod dash has the plastic panel but without any
covering.Just the structured surface of the plastic and a chrome edge added
to the plastic.Weightsavings !? :)
Cost savings!
And I just checked, mine is like yours. I thought it was covered with
material, but it's just molded black plastic...
Mike
**************
Need a job? Find an employment agency near you.
(http://yellowpages.aol.com/search?query=employment_agencies&ncid=emlcntusye
lp00000003)
More information about the DeTomaso
mailing list