[DeTomaso] Carb questions
Mark McWhinney
msm at portata.com
Wed Oct 24 01:10:33 EDT 2007
Ah, good idea. I have some gunk build up, so I will need to do a lot of
cleaning around the manifold. I think I have some scrap 26 gauge metal
sheets and some snips around here somewhere...
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of MikeLDrew at aol.com
Sent: Tuesday, October 23, 2007 8:06 PM
To: asajay at asajay.com; detomaso at realbig.com
Subject: Re: [DeTomaso] Carb questions
In a message dated 10/23/07 7:31:51 PM, asajay at asajay.com writes:
> Yes, I usually stuff a rag down the holes, scrape the gasket, vacuum,
> remove the rage, vacuum again, -then- duct tape it. :)
>
I make a solid cover out of cardboard (using a carb gasket as a template),
and when I pull the carb, I immediately put the cardboard cover in its place
and
secure it with the nuts (finger tight), which has the added benefit of
helping prevent losing the nuts.
You won't need to scrape any gaskets unless something has gone Seriously
Wrong.
Mike
**************************************
See what's new at
http://www.aol.com
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list