[DeTomaso] [BULK] Removing baffle form cast valve covers
Asa Jay Laughton
asajay at asajay.com
Sun Nov 18 01:31:47 EST 2007
Mike,
I'm probably going to take flack for this. I removed the baffles
completely from my valve covers. I have a set of cast aluminum covers
on the Mach I, they came with the baffles, they appeared to cause
interference with the roller rockers, I couldn't see any real use to
them, so out they came. The pins are a press fit and you should be able
to pop them out.
Asa Jay
Asa Jay Laughton, MSgt, USAFR, Retired
& Shelley Marie
Spokane, WA
1973 Pantera L 5533
[ASASCAT]
******************************
http://www.asajay.com
http://www.351c.info
Mike Thomas wrote:
> OK, now that I have the solution for the gasket material, I have another
> question.
>
> My roller rockers were pummeling the baffles in my cast aluminum DeTomaso
> valve covers. I took a ball peen hammer to the spot on the baffle making
> contact, and that solved that problem, but now the baffle on one cover won't
> stay in the keeper at the bottom (top) of the cover. The only way I can see
> to fix that is to remove the baffle and bend it properly so it will stay in
> place. Problem is, I cant figure out how to remove the two pins that hold
> the baffle in place.
>
> I've thought about drilling and tapping a small screw into the edge of the
> baffle to keep it in place, but that would mean it would come through the
> top of the valve cover.
>
> Thanks
> Mike Thomas
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
>
>
More information about the DeTomaso
mailing list