[DeTomaso] Diameter of AC Lines

[Mike Drew]

Mike,

My lines and your lines could easily have different outside diameters. Don’t cut any holes until you have YOUR lines in-hand. 

I would assume you would cut the holes over side and use rubber grommets to protect the lines from being chafed by the body so you would need to have those in hand also….

Mike

Sent from my iPad

> On Sep 1, 2022, at 16:15, Mike & Elizabeth <mbefthomas2 at gmail.com> wrote:
> 
>    I need to cut the hole in the right rear inner fender in my engine bay
>   to run the AC lines out along the frame rail.  Can someone tell what
>   the diameters of the two rubber lines are?  I don't have any of the old
>   lines around the garage to check them.
> 
> 
>   Thanks
> 
>   Mike Thomas
> _______________________________________________
> 
> 
> Detomaso Email List is not managed by POCA
> Posted emails must not exceed 1.5 Megabytes
> DeTomaso mailing list
> DeTomaso at server.detomasolist.com
> http://server.detomasolist.com/mailman/listinfo/detomaso
> 
> To manage your subscription (change email address, unsubscribe, etc.) use the links above.
> 
> Members who post to this list grant license to the list to forward any message posted here to all past, current, or future members of the list. They also grant the list owner permission to maintain an archive or approve the archiving of list messages.