[DeTomaso] Front spindle tolerance
Julian Kift
julian_kift at hotmail.com
Sun Feb 6 23:16:56 EST 2022
It's a $25 bearing, if in any doubt I'd replace it, you are halfway there already...
Julian
________________________________
From: DeTomaso <detomaso-bounces at server.detomasolist.com> on behalf of George B <gkb1968 at hotmail.com>
Sent: Sunday, February 6, 2022 3:40 PM
To: detomaso at server.detomasolist.com <detomaso at server.detomasolist.com>
Subject: [DeTomaso] Front spindle tolerance
Does anyone know the tolerance for Pantera front spindle small bearing OD? I have one that mics out at .7465 when measured 6 to 12 o'clock (top to bottom) and .749 when measured from 3 to 9 o'clock with some minor discoloration. The large bearing area of my spindles seem to be evenly .001 under the bearing ID which is what I expected to see.
I run track days once in a while so want this to be well within spec.
Thanks,
George
-------------- next part --------------
It's a $25 bearing, if in any doubt I'd replace it, you are halfway
there already...
Julian
__________________________________________________________________
From: DeTomaso <detomaso-bounces at server.detomasolist.com> on behalf of
George B <gkb1968 at hotmail.com>
Sent: Sunday, February 6, 2022 3:40 PM
To: detomaso at server.detomasolist.com <detomaso at server.detomasolist.com>
Subject: [DeTomaso] Front spindle tolerance
Does anyone know the tolerance for Pantera front spindle small bearing
OD? I have one that mics out at .7465 when measured 6 to 12 o'clock
(top to bottom) and .749 when measured from 3 to 9 o'clock with some
minor discoloration. The large bearing area of my spindles seem to be
evenly .001 under the bearing ID which is what I expected to see.
I run track days once in a while so want this to be well within spec.
Thanks,
George
More information about the DeTomaso
mailing list