[DeTomaso] Engine rear block plate
Asa Jay Laughton
asajay at asajay.com
Mon Oct 19 22:41:57 EDT 2015
The first I'd ever seen that foam gasket on a 351C was when I pulled the
original engine out of my Pantera. I replaced it with some regular thin
door weatherstripping. I don't really think it's needed though.
Asa Jay
Asa Jay Laughton - W7TSC, MSgt, USAFR, Retired
& Shelley Marie
Spokane, WA
******************************
http://www.racingagainstautism.com
http://www.teampanteraracing.com
http://facebook.com/racingagainstautism
On 10/19/2015 6:35 PM, John McKee wrote:
> I need to clean up and install my block plate that sandwiches between
> the engine block and the ZF bell housing.
>
> Question:
>
> Is there a replacement gasket for the one that is glued around the
> center hole? Mine does not look that bad `I think' but while it is out?
>
>
> I will attempt to attach a picture for clarity and to raise the
> frustration of those who are not getting pictures......
>
>
> Thanks,
>
> John
>
>
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
> Posted emails must not exceed 1.5 Megabytes
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso_poca.com
>
> To manage your subscription (change email address, unsubscribe, etc.) use the links above.
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2015.0.6172 / Virus Database: 4447/10851 - Release Date: 10/19/15
More information about the DeTomaso
mailing list