[DeTomaso] Clutch Line Flaring

[Mike Thomas]

I need to cut the line to my clutch master to install a nut to meet the end
of the fitting on one of the CNC clutch masters.  Can someone who has one of
these tell me if the ends of the connector are 45 or 37.5 degrees?  What was
stock, and can you recommend a good flaring tool set that will do both or
should I stick to one angle?  Will be doing all new brake lines during the
restoration in a few years, so don't mind getting a decent flaring kit.

Thanks
Mike Thomas
Pres., Panteras Northwest
Yellow '74 #6328