[DeTomaso] Quella Adjustable Upper Rear A Arms - Installation Help
MikeLDrew at aol.com
MikeLDrew at aol.com
Sat Jan 31 18:20:48 EST 2015
In a message dated 1/31/15 15 18 9, mbefthomas at comcast.net writes:
> I've got a set of Dennis Quella's adjustable upper rear A arms that I'm
> ready to install, but when I did a test fit to the top of the upright, the
> taper provided with the A arm is much too big. If you have installed a
> set
> of these, did you have to have the hole at the top of the upright machined
> out to fit the larger taper on the Quella A arm? Is there a sleeve pops
> out
> of top of the upright?
>
>>>Nope--normally the taper on the end of the heim joint fits the upright
perfectly. Compare it dimensionally to the ball joint on your stock A-arm?
>
> >I'll call Dennis on Monday to find out, but hoping one of y'all out there
> has an answer before that.
>
>>>Should be a straightforward bolt-in swap with no issues.
Mike
-------------- next part --------------
In a message dated 1/31/15 15 18 9, mbefthomas at comcast.net writes:
I've got a set of Dennis Quella's adjustable upper rear A arms that
I'm
ready to install, but when I did a test fit to the top of the
upright, the
taper provided with the A arm is much too big. If you have
installed a set
of these, did you have to have the hole at the top of the upright
machined
out to fit the larger taper on the Quella A arm? Is there a sleeve
pops out
of top of the upright?
>>>Nope--normally the taper on the end of the heim joint fits the
upright perfectly. Compare it dimensionally to the ball joint on your
stock A-arm?
>I'll call Dennis on Monday to find out, but hoping one of y'all out
there
has an answer before that.
>>>Should be a straightforward bolt-in swap with no issues.
Mike
More information about the DeTomaso
mailing list