[DeTomaso] Engine Cover

[Charles McCall]

A big hammer. Something no home shop should be without

Charles McCall
Raising Pantera Awareness Across Europe
1985 DeTomaso Pantera #9375
http://www.poca.com/index.php/gallery/?g2_itemId=2323


-----Original Message-----
From: detomaso-bounces at poca.com [mailto:detomaso-bounces at poca.com] On Behalf
Of Jack Donahue
Sent: martes, 14 de mayo de 2013 20:45
To: MikeLDrew at aol.com
Cc: detomaso at poca.com
Subject: Re: [DeTomaso] Engine Cover

BFI? Dare I ask?
On May 14, 2013, at 10:50 AM, MikeLDrew at aol.com wrote:

> 
> In a message dated 5/14/13 9 52 17, demongusta at me.com writes:
> 
> 
>> Steve
>> It's 20 1/4" tall and 19 1/2" wide. It's also not straight on the
driver's side. It's curved (bowed) for some reason, I think thats why the
holes are so screwed up. Thought about the welding thing, but it's a lot
easier to replace one, since I cannot weld. Also, that "curved" thing
wouldn't be conducive to welding a straight piece. I just took a picture of
it - will send it immediately.
> 
> >>>This is definitely a job for the BFH! :>)
> 
>> >Jack
>> I would have thought with everyone talking about the flat firewall, there
would be plenty of them around. 
> 
> >>>There are!  Last time I was trying to find one for somebody, there were
a half-dozen offered up, in various stages (some were just bare originals,
while other had been treated to all sorts of coatings, insulation, etc.
etc.)
> 
> Mike

_______________________________________________

Detomaso Forum Managed by POCA

DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso