[DeTomaso] Engine Cover

[Jack Donahue]

BFH=got it.
On May 14, 2013, at 11:52 AM, Charles McCall wrote:

> A big hammer. Something no home shop should be without
> 
> Charles McCall
> Raising Pantera Awareness Across Europe
> 1985 DeTomaso Pantera #9375
> http://www.poca.com/index.php/gallery/?g2_itemId=2323
> 
> 
> -----Original Message-----
> From: detomaso-bounces at poca.com [mailto:detomaso-bounces at poca.com] On Behalf
> Of Jack Donahue
> Sent: martes, 14 de mayo de 2013 20:45
> To: MikeLDrew at aol.com
> Cc: detomaso at poca.com
> Subject: Re: [DeTomaso] Engine Cover
> 
> BFI? Dare I ask?
> On May 14, 2013, at 10:50 AM, MikeLDrew at aol.com wrote:
> 
>> 
>> In a message dated 5/14/13 9 52 17, demongusta at me.com writes:
>> 
>> 
>>> Steve
>>> It's 20 1/4" tall and 19 1/2" wide. It's also not straight on the
> driver's side. It's curved (bowed) for some reason, I think thats why the
> holes are so screwed up. Thought about the welding thing, but it's a lot
> easier to replace one, since I cannot weld. Also, that "curved" thing
> wouldn't be conducive to welding a straight piece. I just took a picture of
> it - will send it immediately.
>> 
>>>>> This is definitely a job for the BFH! :>)
>> 
>>>> Jack
>>> I would have thought with everyone talking about the flat firewall, there
> would be plenty of them around. 
>> 
>>>>> There are!  Last time I was trying to find one for somebody, there were
> a half-dozen offered up, in various stages (some were just bare originals,
> while other had been treated to all sorts of coatings, insulation, etc.
> etc.)
>> 
>> Mike
> 
> _______________________________________________
> 
> Detomaso Forum Managed by POCA
> 
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso
>