[DeTomaso] Stock brake calibers & other musings
Asa Jay Laughton
asajay at asajay.com
Wed May 1 18:20:06 EDT 2013
Did you use the stock DeTomaso studs or something else?
You might also remind folks where you got the rotors before they all go out
and try to buy the "bad" ones.
Asa
Sent using Jedi mind tricks.
-----Original message-----
From: MikeLDrew at aol.com
To: davel at emspace.com, eb0711 at kolumbus.fi
Cc: detomaso at poca.com
Sent: Wed, May 1, 2013 20:59:25 GMT+00:00
Subject: Re: [DeTomaso] Stock brake calibers & other musings
In a message dated 4/30/13 10 40 59, davel at emspace.com writes:
>
> Amen brother!
> When putting in the vented rotor upgrade I had to do the left-front twice.
> I wired brushed the hat and did a careful job of pressing it back together
> and still had 0.050 of runout.
> Second time it was with a wire wheel, until shiny, and had no discernible
> runout.
>
>>>Lori and I (with me taking the photos) just finished this project about
ten minutes ago. The 1965-67 Mustang front rotors fit great!
http://www.poca.com/index.php/gallery/?g2_itemId=39497
I know we did a better job on the second rotor, getting all the mung off
the hub where it indexes on the center of the rotor. I hope we don't have
runout on the first side we did?
Mike
_______________________________________________
Detomaso Forum Managed by POCA
DeTomaso mailing list
DeTomaso at poca.com
http://poca.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list