[DeTomaso] Stock brake calibers & other musings
dave londry
davel at emspace.com
Wed May 1 19:44:41 EDT 2013
Stock, in my case.
dave
On 01/05/2013 3:20 PM, Asa Jay Laughton wrote:
> Did you use the stock DeTomaso studs or something else?
>
> You might also remind folks where you got the rotors before they all
> go out and try to buy the "bad" ones.
>
> Asa
>
> /Sent using Jedi mind tricks./
>
>
> -----Original message-----
>
> *From: *MikeLDrew at aol.com*
> To: *davel at emspace.com, eb0711 at kolumbus.fi*
> Cc: *detomaso at poca.com*
> Sent: *Wed, May 1, 2013 20:59:25 GMT+00:00*
> Subject: *Re: [DeTomaso] Stock brake calibers & other musings
>
>
> In a message dated 4/30/13 10 40 59, davel at emspace.com writes:
>
>
> >
> > Amen brother!
> > When putting in the vented rotor upgrade I had to do the
> left-front twice.
> > I wired brushed the hat and did a careful job of pressing it
> back together
> > and still had 0.050 of runout.
> > Second time it was with a wire wheel, until shiny, and had no
> discernible
> > runout.
> >
>
> >>>Lori and I (with me taking the photos) just finished this
> project about
> ten minutes ago. The 1965-67 Mustang front rotors fit great!
>
> http://www.poca.com/index.php/gallery/?g2_itemId=39497
>
> I know we did a better job on the second rotor, getting all the
> mung off
> the hub where it indexes on the center of the rotor. I hope we
> don't have
> runout on the first side we did?
>
> Mike
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> DeTomaso mailing list
> DeTomaso at poca.com
> http://poca.com/mailman/listinfo/detomaso
>
More information about the DeTomaso
mailing list