[DeTomaso] Wilkinson Headers
Mike Thomas
mbefthomas at comcast.net
Thu Mar 1 20:54:26 EST 2012
They are brand new, and Steve didn't even hesitate to ask that I send them
back when I talked to him. He sounded very surprised. One is actually 1/8"
warped, the other 1/16", very visible in either case. He suspects being
pulled out of the jig before they had cooled properly.
Mike
-----Original Message-----
From: larry gilmore [mailto:mgilmore11 at mchsi.com]
Sent: Thursday, March 01, 2012 9:30 AM
To: Mike Thomas
Subject: Re: [DeTomaso] Wilkinson Headers
Hi! That sounds like very poor (or NO) quality control. Hope you bought them
cheap. Were they 2nds, or rejects? Keep us posted. Good luck!
----- Original Message -----
From: "Mike Thomas" <mbefthomas at comcast.net>
To: <detomaso at realbig.com>
Sent: Thursday, March 01, 2012 7:52 AM
Subject: [DeTomaso] Wilkinson Headers
> I just received a set of Steve Wilkinson's new stainless GTS headers
> and pipes. Beautiful pieces, but I've a question. The header flange
> on one side has a rather significant concave bow, I assume warping
> from the
welding
> process. It's about 1/4" such that the ends will touch the head, the
center
> is bowed out. Opinions? Will this be something that will correct
> itself when I bolt them up, or is this too much distortion to try to deal
with.
> I'm concerned the stresses of straightening the flange may compromise
> the welds in the header.
>
> I'm going to call Steve and talk to him as well, but thought I'd toss
> it
out
> to the forum for thoughts.
>
> Thanks
> Mike Thomas
> Panteras Northwest
> Yellow '74 L #6328
>
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at
> http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list