[DeTomaso] Wheel offset (ET)

[Bjoern Flesland]

But stampings does not match quite up with the calculations that Tomas did.

So I am confused!
Can it be measured in different ways?
Cheers Bjoern

Sent from my iPhone


Den 1. aug. 2012 kl. 20:08 skrev "michael at michaelshortt.com" <michaelsavga at gmail.com>:

> Yes, I think that is exactly what that means.
> 
> Michael Shortt
> 
> 
> 
> On Wed, Aug 1, 2012 at 1:06 PM, Bjoern Flesland <bflesland at gmail.com> wrote:
>> Thanks for helping out.
>> They are stamped the following:
>> 
>> Front
>> 28 85 8 LA3
>> 8.5JX18H2E64
>> 
>> Rear
>> 28 13 8 LA
>> 13JX18H2E39
>> 
>> Could that indicate ET of 64 and 39 mm?
>> 
>> Cheers Bjoern
>> Sent from my iPhone
>> 
>> 
>> Den 1. aug. 2012 kl. 19:36 skrev "Tomas Gunnarsson" <guson at home.se>:
>> 
>> If you have used the same edges as reference for all measurements the narrow
>> rim has ET70 and the wide rim ET51.
>> 
>> Tomas
>> 
>> <-----Ursprungligt Meddelande----->
>> From: Bjoern Flesland [bflesland at gmail.com]
>> Sent: 1/8/2012 6:22:47 PM
>> To: POCA Detomasolist Realbig
>> Subject: [DeTomaso] Wheel offset (ET)
>> 
>> I am trying to determine the offset (ET) of two wheels and need some advise:
>> 
>> One wheel measure 184 mm from the mounting face/flange to the inner rim
>> edge.
>> Wheel width is 228 mm.
>> 
>> The other measure 216 mm from the mounting face/flange to the inner rim
>> edge.
>> Wheel width is 330 mm.
>> 
>> Appreciate your help. Thanks!
>> Cheers Bjoern
>> 
>> _______________________________________________
>> 
>> Detomaso Forum Managed by POCA
>> 
>> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>> 
>> DeTomaso mailing list
>> DeTomaso at list.realbig.com
>> http://list.realbig.com/mailman/listinfo/detomaso
>> .
> 
> 
> 
> -- 
> 
> 
> 
> 
> 
> 
> 
> Michael L. Shortt
> Savannah, Georgia
> www.michaelshortt.com
> michael at michaelshortt.com
> 912-232-9390
> 
> 
> This email is protected by the Electronic Communications Privacy
> Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
> privileged.  If you are not the intended recipient, you are hereby notified
> that any retention, dissemination, distribution or copying of this
> communication is strictly prohibited.  Please reply to the sender that you
> have received this message in error, then delete it.  Thank you