[DeTomaso] gas tank float switch

[Charles Engles]

Dear Richard,


              Ach du Lieber!  That is the problem that I am having.

             I have a new gas tank sender and pick up modified after
purchase for a larger gas line that was installed and didn't work.  I found
that the float was hitting the side of the tank.  I tweaked it and it had
full range of motion within the tank.    Then, once "fixed" it does "work",
but all the readings are lower than normal.   So, which way do you bend the
float arm to approach a correct reading?


                    Warmest regards,  Chuck Engles



-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of richard bosch
Sent: Tuesday, April 03, 2012 8:25 PM
To: detomaso at realbig.com; boyd411 at gmail.com
Subject: Re: [DeTomaso] gas tank float switch

Boyd,i believe that the other vendors get them from Wilkinson so i doubt
anyone else would be cheaper.For what it is worth i have installed a few of
these new ones and the float arm has needed to be adjusted(bent) to get a
closer to accurate reading.All the ones i have installed had initially read
less fuel than was really in the tank.So adjust it before putting all the
screws and the side window back in.And yes i know the fuel tank is not
square so you need to adjust for that as well.
_______________________________________________

Detomaso Forum Managed by POCA

Archive Search Engine Now Available at http://www.realbig.com/detomaso/

DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso