[DeTomaso] Suspension bushings - extraction

[JDeRyke at aol.com]

In a message dated 4/1/12 10:26:05 AM, fisher95020 at yahoo.com writes:

> Straightening, however, looks to be a much easier task than removing the
> bushings.   It appears that a piece of solid shaft should run precisely 
> through
> both A -arm ends without binding. 
> 

Yup- just heat the critical area with a torch and twist to align. It can be 
done cold, but heating is easier and doesn't affect the metal as much. If 
you made an alignment shaft, the job is simple. You're likely going to paint 
the a-arms anyway. Good luck- JDeRyke