[DeTomaso] Any experience with rivnut, nutsert, rivet nut tools
Ken Green
kenn_green at yahoo.com
Sun Mar 27 21:17:19 EDT 2011
Thanks Michael,
I suspect yours is made better than the Harbor freight tool. I think some of the less sturdy tools may not work with steel (versus aluminum) nuts, and may be limited to smaller size nuts.
Ken
--- On Sun, 3/27/11, michael at michaelshortt.com <michaelsavga at gmail.com> wrote:
From: michael at michaelshortt.com <michaelsavga at gmail.com>
Subject: Re: [DeTomaso] Any experience with rivnut, nutsert, rivet nut tools
To: "Ken Green" <kenn_green at yahoo.com>
Cc: detomaso at realbig.com
Date: Sunday, March 27, 2011, 4:30 PM
i just sent you pix of mine, called Thread Setter. I bought it at Grainger Supply, cost a little over $100. its nice, nut i saw a twin knock off at Harbor Freight for 29 bucks. so, i don't know if they are equal, i doubt it, but 300% better? you can see mine in action on my website on the trunk latch adventure.
WWW.michaelspantera.com
Michael Shortt
On Mar 27, 2011 5:41 PM, "Ken Green" <kenn_green at yahoo.com> wrote:
> The prices for the tools seem to go from $20 to $500. if anyone has used one that works well I would appreciate your comments.
>
> Thanks,
>
> Ken
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list