[DeTomaso] MSD distributors - WTF?
MikeLDrew at aol.com
MikeLDrew at aol.com
Mon Jun 27 20:36:13 EDT 2011
In a message dated 6/27/11 16 34 23, gaino at earthlink.net writes:
> Erik, I rebuilt my motor and the dizzy fit before. NOW I cannot fit the
> engine screen. The engine mounts that bolt to the frame should be on the
> correct sides that place the engine to the rear. I think I have mine wrong. It
> is only an inch or so.. The stands fit either side, but the holes is off
> center... Check yours... Bill 1362
>
That's just swapped mounts, an easy mistake to make. The upper mounts are
the same, the lower ones are handed. Just swap them side-to-side.
Another way to make your distributor not fit is to install new rubber motor
mount bushings. Mine had collapsed and the distributor barely fit; the
new ones raised it just enough to create slight interference. My screen (as
it turns out) had been dented inwards; some creative malletizing fixed the
problem.
Mike
More information about the DeTomaso
mailing list