[DeTomaso] Fw: Re: Pantera fall down go boom :<(
JDeRyke at aol.com
JDeRyke at aol.com
Fri Jun 24 16:23:14 EDT 2011
In a message dated 6/24/11 10:31:26 AM, davel at emspace.com writes:
> My alternative is -.... a 5/8 x 1/2" UNF internal hex plug. I should be
> able to buy that in brass which would be drillable. Anyone know a reason not
> to use brass in that spot?
>
>
IMHO no problem with brass- as long as the thread's the same and there's
enough material left in the internal hex drive to tighten the plug in so the
plug goes in flush. Matter of fact, aluminum should work as well too. Both
would be much more drillable in the smaller sizes than harder steel. Going
too big in your spray hole simply floods the gear mesh area and might reduce
the oil supply in that galley- which is a main lube channel for the vital
mains & rods. The bad effects might not show up until the revs are high for a
long time. FWIW- J Deryke
More information about the DeTomaso
mailing list