[DeTomaso] Alignment Specs.....revisited
John Buckman
jb841 at cox.net
Thu Aug 4 22:35:48 EDT 2011
"At a minimum, you should mill .100" off the back side of the upper ball
joints."
Yes, that's about the right number. I made the calculation shortly after the alignment,
and I figured that I needed to mill the ball joint .104" in order to gain the 0.8*. That
would bring the right side to 3.0*, which matches the left side.
A while back, I did mill .100" off of an old upper ball joint, just to see how it looked. As I
recall, it kind of left the boot overhanging into the the area that was removed. I need to
revisit this by drilling a hole into the ball joint (perpendicular to the milled face) just to see
how much "meat" is left.
John (who doesn't have milled balls in his '71, or anywhere else ; >)
More information about the DeTomaso
mailing list