[DeTomaso] water pump mounting hole repair

Doug Braun doug at silicondesigns.com
Wed Jun 2 14:33:26 EDT 2010


For two reasons

1) Because I don't want to ruin the valuable 1970 original water pump
casting by drilling it's thru hole out to 3/8".

2) The judges check the heads and head markings on the water pump bolts.
These are indented head bolts which if you file down an indented 3/8 head,
the indent will disappear.

Do you think that not enough meat will be present in the casting to support
the threaded-insert?

Doug

-----Original Message-----
From: detomaso-bounces at realbig.com
[mailto:detomaso-bounces at realbig.com]On Behalf Of JDeRyke at aol.com
Sent: Wednesday, June 02, 2010 10:25 AM
To: doug at silicondesigns.com; detomaso at realbig.com
Subject: Re: [DeTomaso] water pump mounting hole repair


Doug, since you seem to want to rescue this thing at any cost, why not take
the oversize 3/8" bolt and carefully file its hex down to a 5/16"-size. In
place, no judge will see the bolt threads or shank. Whatever, good luck- J
Deryke







More information about the DeTomaso mailing list