[DeTomaso] More valvetrain for 6143
Thomas Tornblom
Thomas.Tornblom at hax.se
Fri Jan 22 07:06:06 EST 2010
Without personal experience of Ford big blocks, I had a look in Tom
Monroes book, and he says they also have 11/32" valve stems, which is
consistent with the info I remember from when I was hunting for valves.
Thomas
jderyke at aol.com skrev:
> In a message dated 1/21/10 1:53:40 PM, guson at home.se writes:
>
>> I was under the impression that the solution was to use Boss retainers
>> with aftermarket keepers but if there are Boss keepers that fit the stock
>> retainers I'd rather get that I guess. If these are stock Boss retainers they
>> look nothing like mine anyway:
>>
> You're right- in that article, the retainers pictured are not stock steel
> retainer washers. Stockers are the same for 260, 289, 302 and 351 engines,
> both Windsor & Cleveland. In the article, they say the valves were replaced
> with Pro Comp one-piece single-groove stainless valves, so I guess they also
> supplied the single groove keepers and aftermarket retainers.
> Big block keepers will be sized for 3/8" big block valve stems, so whether
> they're too big to fit 351C retainers or not is a moot point; big block
> valve stems won't fit in the 351-Cs' 11/32" valve guides. 429/460 stuff is very
> different even if the valve and port sizes are similar to the 4-V Cleveland.
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
> !DSPAM:4b591d27238721810116612!
>
--
Real life: Thomas Törnblom Email: Thomas.Tornblom at Hax.SE
Snail mail: Banvallsvägen 14 Phone: +46 18 444 33 21
S - 754 40 Uppsala, Sweden Cellular: +46 70 261 1372
More information about the DeTomaso
mailing list