[DeTomaso] Flex Water Tube to water pump
jderyke at aol.com
jderyke at aol.com
Tue Jan 12 02:25:51 EST 2010
In a message dated 1/10/10 4:06:04 PM, teampantera at yahoo.com writes:
> Has anyone used *flex-hose* to replace the short water tube that comes
> off water pump that requires rubber hose on both ends? ?
>
> Its 2" on one end and 1&1/2" on the other. Both ends need short pieces
> of Gates rubber hose and clamps but I would like to use a *better* idea if
> one exists.
>
Flex hose usually slows down water or air flow going through it. In '74,
the factory introduced a twisty steel tube that fits around the gearshift
shaft and is 2" on one end & 1-1/2" on the other. So yes- you need two short
pieces of straight hose to connect it. The factory did this change from a
single hose with two different diameter ends because they found very early in
production that running vibration will cause the gearshift shaft to rub clear
through the hose. There's a TSB (Bull. 12, article 101) covering this part
-stock after May '74, and all the vendors sell copies of the factory piece-
most in stainless as part of their kit. I wouldn't use a one piece rubber
hose, corrugated or not here because of the rubbing problem and lack of space to
reroute it. Good luck- J DeRyke
More information about the DeTomaso
mailing list