[DeTomaso] bearing race
Tomas Gunnarsson
guson at home.se
Tue Sep 22 07:05:49 EDT 2009
Almost. The bearing that had spun was the corresponding bearing for the
input shaft. It sits right next to 403 and is of slightly smaller size.
The price was about the same though... I ended up having the hole in the
case enlarged and sleeved. The bearing seat was both oversize and
elongated from the spinning incident. The machine shop used the iron end
cap for reference to get the hole positioned right.
Tomas
<-----Ursprungligt Meddelande----->
From: JDeRyke at aol.com [JDeRyke at aol.com]
Sent: 22/9/2009 1:41:18 PM
To: guson at home.se; DeTomaso at realbig.com
Subject: Re: [DeTomaso] bearing race
In a message dated 9/22/09 2:10:43 AM, guson at home.se writes:
> The 403 bearing is a straight roller, not tapered.
>
Absolutely right! Its been quite awhile since I had one apart far enough
to
get to this bearing. Isn't that the one that spun in your ZF, Tomas? As
I
rememberr, it was torn up pretty good. Since you did fix it, you're the
expert! Sorry- J Deryke
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
.
<P><p><font face="Arial, Helvetica, sans-serif" size="2" style="font-size:13.5px">_______________________________________________________________<BR><a style="font-family: Tahoma, sans-serif; font-size: 10px; color: #00f" href="http://www.eniro.se/?partnerid=spray_mail" target="_blank">Eniro Supersök - är vad det heter</a></font>
More information about the DeTomaso
mailing list