[DeTomaso] hot start problem solved
Thomas Tornblom
Thomas.Tornblom at hax.se
Fri Oct 23 08:49:00 EDT 2009
Sounds like it could be a bad starter relay (solenoid)
Thomas
Espen Graffer skrev:
> Thanks, that's interesting!
> But you fixed your problem with two different solutions. So, which one did
> the trick?
> (ie, did you test without the extra groundstrap?)
>
> espen in norway
>
> ---------
> Boyd wrote:
> I know many of you have suffered the same frustrations I have trying to
> resolve a hot start problem. I tried many things like replacing my ignition
> block and checking my ignition switch and various grounds and cables. I
> bought a DR gear reduction high torque starter and the problem was still
> unresolved. I contacted the people at DR ( you may remember a few months ago
> there were several posts regarding their $49.99 starter. The are super nice
> people. In spite of the fact that I bought my starter 6 months ago they sent
> me a replacement within 15 minutes of my calling them. I got an e-mail from
> UPS within 15 minutes of hanging up the phone. I had not installed the
> starter until last week because of delays in working on my car brought on by
> my broken leg. The point of my story is that the guys at DR insist that the
> starter be wired differently then the standard installation as shown in the
> wiring diagrams. Normally the hot lead goes from the battery to the fire
> wall mounted solenoid and then from the solenoid to the starter. many people
> then run a small jumper from the small pole on the starter solenoid to the
> large pole where the 12 volt line from the fire wall solenoid goes to. The
> people from DR say you must run the 12 volt line from the HOT SIDE of the
> fire wall solenoid directly to the large pole on the starter solenoid. In
> other words you have a constant hot 12 volts at the starter at all times.
> You then run a small wire (that they include) from the switched side of the
> fire wall sloenoid to the small pole on the starter solenoid that triggers
> the starter when you turn the ignition switch. I was amazed by the
> difference. My starter rips now when I start it and at full operating
> temperature there is virtually no difference in the starting power. If you
> have been having this problem I strongly recommend you try their starter and
> this wiring plan. ( I also ran a new ground strap from one of the starter
> studs to the chassis)
> Boyd
>
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
> !DSPAM:4ae1a35827873343511756!
>
--
Real life: Thomas Törnblom Email: Thomas.Tornblom at Hax.SE
Snail mail: Banvallsvägen 14 Phone: +46 18 444 33 21
S - 754 40 Uppsala, Sweden Cellular: +46 70 261 1372
More information about the DeTomaso
mailing list