[DeTomaso] lower pantera shafts

[Göran Malmberg]

There also are a distance tube ouside the shaft that 
will be cut and lost in such action.
Goran




-----Ursprungligt meddelande-----
Från: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com]
För bill gaino
Skickat: den 2 oktober 2009 20:39
Till: MikeLDrew at aol.com; detomaso mailing
Ämne: [DeTomaso] lower pantera shafts

Mike,Listers, I'm in trouble. I had a grinding noise and noticed my RR
inboard bearing was missing a few balls. Lucky for me I have a set of
rebuilt uprights and new lower shafts, seals O rings, the works,
including ball joints. I got the right side off and the upper arm built.
I bent my press trying to push the lower shaft out. It is stuck in the
inner sleeve. Can I cut between the lower arm and the upright with a
sawzall? I just need my lower arm back but I don't want to harm a good
upright either. The exiting lower shaft means nothing to me now. Any
suggestions.   Bill 1362
_______________________________________________

Detomaso Forum Managed by POCA

Archive Search Engine Now Available at http://www.realbig.com/detomaso/

DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso