[DeTomaso] DeTomaso Digest, Vol 58, Issue 24-Solid Rotors

[Ken Green]

Bob,
 
    By solid, I meant one single solid disk with the pads on opposite faces of the disk, like most motorcycle rotors.  I think you are distininguishing between drilled and un-drilled, vented rotors?  
 
Ken

--- On Tue, 5/26/09, RCBSONS1 at aol.com <RCBSONS1 at aol.com> wrote:


From: RCBSONS1 at aol.com <RCBSONS1 at aol.com>
Subject: Re: [DeTomaso] DeTomaso Digest, Vol 58, Issue 24-Solid Rotors
To: kenn_green at yahoo.com, detomaso at realbig.com
Date: Tuesday, May 26, 2009, 8:43 AM


Ken.
The Wilwoods are a solid piece at least 1/4" thick one on
the outside and one on the inside with a venting system
between that is approx 1/2" wide.... but the rotors 
are solid on each side... no holes as the venting system
goes between them.. I call these solid rotors but I guess
you would also say they are vented just to clairify...
The Mustang is the similar but not as big

Again no fading

Bob
**************A Good Credit Score is 700 or Above. See yours in just 2 easy 
steps! 
(http://pr.atwola.com/promoclk/100126575x1222377034x1201454326/aol?redir=http://www.freecreditreport.com/pm/default.aspx?sc=668072&hmpgID=62&bcd=
MaystepsfooterNO62)
_______________________________________________

Detomaso Forum Managed by POCA

Archive Search Engine Now Available at http://www.realbig.com/detomaso/

DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso