[DeTomaso] I could use some help
ProvaMo.com
Pantera007 at provamo.com
Sat Mar 7 20:11:44 EST 2009
The Ford Rotunda ball joint removal tool?
Chuck
> I am taking my suspension apart for powder coating. Any ideas on the best
> way to remove the upper rear ball joint from the A arm??
>
Bill, it simply presses in. First, remove the fragile rubber boot. Then use
an 'appropriate' sized piece of water pipe (or pipe fitting) over the stud and
gainst the ball joint body and tap or press it out. Most move uncomfortably
easy for their function..... Note when putting it back in that there's a
specific direction- the slot on the upper balljoint body should align with the rear
upright so the slot in the top allows the stud & a-arm to move without
interference. Good luck- J Deryke
**************
A Good Credit Score is 700 or Above.
See yours in just 2 easy steps!
(http://pr.atwola.com/promoclk/100126575x1219957551x1201325337/aol?redir=http:%2F%2Fww
w.freecreditreport.com%2Fpm%2Fdefault.a
spx%3Fsc%3D668072%26hmpgID%3D62%26bcd%3DfebemailfooterNO62)
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.11.8/1984 - Release Date: 3/4/2009 7:17 PM
More information about the DeTomaso
mailing list