[DeTomaso] Cranky Question
JDeRyke at aol.com
JDeRyke at aol.com
Thu Oct 2 16:47:42 EDT 2008
In a message dated 10/1/08 6:17:56 PM, tonydigi at optonline.net writes
> Could it be any better or worse than a factory stock crank?
>
Possibly not, but you can check it a few ways:
Cheap way- CAREFULLY hang the thing from a beam in the garage or a tree limb-
(it weighs 52+ lbs!) and tap it on a few of the counterweights with a steel
hammer. If it's OK, it will ring like a bell. If its cracked, you'll get a dull
thud with the hammer.
Expensive way- magneflux at an engine shop, who may also be able to ID it.
Most common third way- build it into a motor with your fingers crossed until
you stress it and it doesn't immediately become two-or-more-piece! Good luck-
J Deryke
**************
Looking for simple solutions to your real-life financial
challenges? Check out WalletPop for the latest news and information, tips
and calculators.
(http://www.walletpop.com/?NCID=emlcntuswall00000001)
More information about the DeTomaso
mailing list