[DeTomaso] exhaust gasket for Hall big bore
Dave McManus
dave at damardirect.com
Tue Jul 29 09:33:59 EDT 2008
BIG BORE GASKETS:
Big Bore exhaust to header.
NAPA part number 31 381 about $9.00 ea.
Gasket has about a ¼ steel ring (inside of the donut) that extends out of
one side of the donut. Works well.
IndyDave
-----Original Message-----
From: Lee Farrell [mailto:lee_farrell at sbcglobal.net]
Sent: Monday, July 28, 2008 5:12 PM
To: detomaso at list.realbig.com
Subject: [DeTomaso] exhaust gasket for Hall big bore
Does anyone have advice for the gasket at the header-to-exhaust pipe
interface, from a Hall big bore to a stock exhaust pipe? The SOBill data
base says Fel-Pro 2014, with a 2 1/2 inch ID. This looks fine for the
stock exhaust section. But the Hall output is a flare or bell shape, with
only a lip for a flat surface, and barely reaches to 2 1/2 width by my rough
measurement. There would be very little, if any, gasket under the flared
lip.
Or do you use a "donut" gasket, like Steve Wilkinson lists?
thanks
lee farrell
More information about the DeTomaso
mailing list