[DeTomaso] exhaust gasket for Hall big bore
Will Kooiman
wkooiman at earthlink.net
Mon Jul 28 18:21:36 EDT 2008
I've used the white Mr. Gasket gaskets with success, but I think the donuts
to a better job of sealing.
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of Lee Farrell
Sent: Monday, July 28, 2008 4:12 PM
To: detomaso at realbig.com
Subject: [DeTomaso] exhaust gasket for Hall big bore
Does anyone have advice for the gasket at the header-to-exhaust pipe
interface, from a Hall big bore to a stock exhaust pipe? The SOBill data
base says Fel-Pro 2014, with a 2 1/2 inch ID. This looks fine for the
stock exhaust section. But the Hall output is a flare or bell shape, with
only a lip for a flat surface, and barely reaches to 2 1/2 width by my rough
measurement. There would be very little, if any, gasket under the flared
lip.
Or do you use a "donut" gasket, like Steve Wilkinson lists?
thanks
lee farrell
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list