[DeTomaso] Plug gap for MSD - one more time
Don Thomas
dtpantera at gmail.com
Sat Jul 26 01:41:39 EDT 2008
Mike,
The plug gap will be base on the compression and the coil you use...
I set my plugs @ 0.046" for a quenched chamber @ 10.5:1. and I may open them
up to 0.050" after re-reading this... But then again... the 0.046" gap is
working just fine...
Take a look at page 3 of the MSD-6 series manual.... that should give you a
good starting point.
http://www.msdignition.com/pdf/6%20series/6series.pdf
I hope this helps...
Best regards,
-dt
>
> Is there a specific plug gap to check for when running an MSD ignition
> system?
> Mike Thomas
>
More information about the DeTomaso
mailing list