[DeTomaso] Camber brace pic requested

[michael@michaelshortt.com]

I do.

I'll go take a fresh shot and sent it to you.

Michael in Savannah




On Feb 18, 2008 7:10 PM, <rimov at charter.net> wrote:

> Afternoon;
>
>
> Does anyone have any pics of the double camber brace like the one
> Precision Performance sells. Their new web site does not show the brace very
> well. I am fashioning my own and want to use stainless rod bearing ends
> (Heim joints) rather than a bushing. I am getting quite a bit of cracking of
> the paint around the boxed ends of my camber brace housing and think by
> having additional attachment points I can slow or stop the current cracking.
> Not really ready to do the repaint the engine bay thing again even though
> the engine is out. Please send pics to rimov at charter.net
>
> Thanks
>
> Paul
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>



-- 
Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael at michaelshortt.com


This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged.  If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited.  Please reply to the sender that you
have received this message in error, then delete it.  Thank you