[DeTomaso] Cam and lifter recommendations
Larry - Ohio Time Corp
larry at ohiotimecorp.com
Wed Feb 6 10:55:23 EST 2008
Will,
I think your stock motor also has the two part stock valves. They started
life as two parts then were welded into one valve. There are a lot of them
that have gone back to being two parts. Having a valve fall into a cylinder
as the motor is running is not a good thing.
Sorry to say pull the heads, replace the valves, a bit of porting and head
work and you will never have a problem with them.
Larry (you and pay now or pay more later) - Cleveland
PS Dan my valves will be shipped to you this week.
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of Daniel C Jones
Sent: Tuesday, February 05, 2008 6:56 PM
To: detomaso at realbig.com
Subject: Re: [DeTomaso] Cam and lifter recommendations
> What cam and lifters would be a good replacement for a 72 351C?
> The motor is bone stock except for headers, a performer intake
> and 750 holley. I think it has CC heads and low compression (72).
That should be open chamber heads and low compression.
> I want to keep the stock valve springs.
Why?
> I want a bit of lump with decent low-midrange.
Isky 264 Megacam:
264/264 214/214 0.525"/0.525" 108
but I'd put some new valve springs in.
Dan Jones
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list