[DeTomaso] Choke wire
SOBill at aol.com
SOBill at aol.com
Sat Apr 5 01:16:42 EDT 2008
Depends on the carburetor you have.
All Holley carbs use 12V to heat the choke. From the plus terminal of the
Holley choke, route a wire to Fuse 11 or 12. You will also need to make a
ground wire from the minus terminal on the choke to the chassis. Do not connect
the choke plus wire to either the alternator plus terminal or the right hand
big terminal on the the starter solenoid on the passenger side of the
firewall. If you do, the choke heater will be on 100% of the time. Do not connect the
choke plus wire to any terminal on the ignition coil. If you have an MSD
ignition, you can connect the choke plus wire to the small Red wire which goes
to ignition module.
Ford/Autolite carbs use 6V for the heater. 6V can be obtained by slicing a
wire from the center tap of the Stator windings (Green/Red wire) at the
alternator to the single terminal on the choke housing. 6V is available at this
connection when the engine is running.
Have fun,
SOBill Taylor
sobill at aol.com
In a message dated 4/4/2008 5:53:28 P.M. Pacific Daylight Time,
wdemelo at cogeco.ca writes:
Where does the electric choke wire get fed from? Any switched 12+ ?
Will
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
**************Planning your summer road trip? Check out AOL Travel Guides.
(http://travel.aol.com/travel-guide/united-states?ncid=aoltrv00030000000016)
More information about the DeTomaso
mailing list