[DeTomaso] Ford 460 and zf
Thomas Tornblom
Thomas.Tornblom at hax.se
Sun Sep 2 19:18:58 EDT 2007
MikeLDrew at aol.com skrev:
> In a message dated 9/2/07 16 03 28, biancoj at aol.com writes:
>
>
>> Does anyone know will a ford 460 block bolt up to a zf trans and if so has
>> anyone done it.
>>
>
> Quite a few people are now running these motors now (or rather, a stroker 514
> version), as Precision ProFormance has been selling this package for years.
> Yes, the bellhousing bolts right up if my memory is correct. However it's a
> non-trivial installation, since the motor is longer than the 351C so it pushes
> the gearbox rearwards quite a bit. Besides the obvious (exhaust, water
> plumbing, throttle cable etc.), transaxle mounts need to be changed, the back of
> the car has to be hacked a bit to accomodate the tail of the gearbox, and
> driveshafts are tweaked at a rather extreme angle, so CV joint driveshafts are
> recommended.
As far as I know the bigblocks has another bellhousing. This is what
makes some of the old 400:s attractive, most of them has the bigblock
bellhousing and won't work with a stock pantera bellhousing, but there
were some with a dual pattern that has the same smallblock bolt pattern.
>
> Bottom line--it can be done, and the results can be worthwhile, but bring
> money. LOTS of money....
>
> Mike
Thomas
More information about the DeTomaso
mailing list