[DeTomaso] Ford 460 and zf
MikeLDrew at aol.com
MikeLDrew at aol.com
Sun Sep 2 19:13:37 EDT 2007
In a message dated 9/2/07 16 03 28, biancoj at aol.com writes:
> Does anyone know will a ford 460 block bolt up to a zf trans and if so has
> anyone done it.
>
Quite a few people are now running these motors now (or rather, a stroker 514
version), as Precision ProFormance has been selling this package for years.
Yes, the bellhousing bolts right up if my memory is correct. However it's a
non-trivial installation, since the motor is longer than the 351C so it pushes
the gearbox rearwards quite a bit. Besides the obvious (exhaust, water
plumbing, throttle cable etc.), transaxle mounts need to be changed, the back of
the car has to be hacked a bit to accomodate the tail of the gearbox, and
driveshafts are tweaked at a rather extreme angle, so CV joint driveshafts are
recommended.
Bottom line--it can be done, and the results can be worthwhile, but bring
money. LOTS of money....
Mike
**************************************
Get a sneak peek of the all-new
AOL at http://discover.aol.com/memed/aolcom30tour
More information about the DeTomaso
mailing list