[DeTomaso] Size for half shaft bolts washers
MikeLDrew at aol.com
MikeLDrew at aol.com
Thu Oct 25 17:47:35 EDT 2007
In a message dated 10/25/07 1:22:47 PM, red3644 at hotmail.com writes:
>
>
> I'm putting 1/2 shafts back in later. I found the new nuts and bolts I
> bought but have lost the washers.
> Now I can't visualize what I had on the other cars. The stock and AN bolts
> fit so tight in the flanges that I
> don't think a washer is needed there although I probably used one before.
> I'm thinking just a flat thin washer
> under the NyLock nuts would do. 7/16-20 size washers? Thanks.
>
The stock setup didn't use washers at all. Due to tight clearances, it's
likely that a washer would hit somewhere and would have to be relieved anyway.
Mike
**************************************
See what's new at
http://www.aol.com
More information about the DeTomaso
mailing list