[DeTomaso] Trunion for ZF linkage
JDeRyke at aol.com
JDeRyke at aol.com
Tue Oct 9 20:01:10 EDT 2007
In a message dated 10/9/07 4:23:55 PM, jimgray at cableone.net writes:
> It appears that if this height adjustment is off the linkage could contact
> the side of the bellhousing.
> Mine seems exceedingly close and I'm wondering if it may at time interfere
> with shifting.
>
Correct, especially if things get over-hot back there or if the motor mounts
get a little loose. I'd lower it a bit, or consider shifting the whole
powertrain backwards a little. This will not only move the bellhousing out of range,
it will give a little more room for a big-cap distributor. The shifter u-joint
will accept quite a bit of misalignment. On some Panteras, the side-to-side
adjustment in the frame mounting hole is also off and the linkage then gets
very close to the leading edge of the inner wheelwell. With this problem, you
have the option of pounding a small dent in the fender. Good luck- J Deryke
**************************************
See what's new at http://www.aol.com
More information about the DeTomaso
mailing list