[DeTomaso] the first day (NUTS!)Wheel bearings
MikeLDrew at aol.com
MikeLDrew at aol.com
Mon Oct 1 14:37:38 EDT 2007
In a message dated 10/1/07 10 17 42, guson at home.se writes:
>
>
> What seems to have gone wrong in Mike's case is that the washer between the
> nut and the bearing looks like it's begun to spin. Unless that washer comes
> loose there is no turning force on the nut and hence no shearing load on the
> nut. It's important to A: have a healthy tounge on that washer to fit the
> spindle axle groove and B: not have an oversize washer which flops around on the
> axle.
>
>>>That's exactly right. In fact the tongue on that washer was stripped
away also. Rotation of the bearing could thus spin the washer, which in turn
could turn the nut.
Curiously, the left spindle is reverse thread so that any unwanted rotation
would tend to tighten, not loosen the nut. I can only assume that the nut
loosened while backing out of the garage, and then was loose for the whole drive
down to San Francisco? Odd that there were no indications for over an hour
of driving though.
Mike
**************************************
See what's new at http://www.aol.com
More information about the DeTomaso
mailing list