[DeTomaso] Oil Temp Gauge Wiring

[SOBill at aol.com]

Art,
 
My Guess: Autometer is making sure that a good ground exists by  telling you 
to install one. A properly grounded mount for the oil pressure  sender should 
work just fine.
 
SOBill  Taylor
sobill at aol.com  

 
In a message dated 11/26/2007 1:25:50 P.M. Pacific Daylight Time,  
artstephens at charter.net writes:

I am planning to install an Autometer electric oil temp  gauge.  The 
instructions read, "route 18-gage wire from center terminal  GND (-) on back of gauge 
to good ground near sender".  Is there some good  reason I have to run the 
ground wire all the way back near the sender?   Is there any problem just finding 
a good ground near the gauge?  Isn't a  good ground just a good ground?  Bill 
Taylor,  are you  listening?

Thanks,
Art
_______________________________________________

Detomaso  Forum Managed by POCA

Archive Search Engine Now Available at  http://www.realbig.com/detomaso/

DeTomaso mailing  list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso






**************************************Check out AOL's list of 2007's hottest 
products.
(http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001)