[DeTomaso] Fw: Transaxle removal

[Douglas Kelm]

> HELP! I need some prompt and accurate information. How many bolts hold the
> bellhousing to the engine block, NOT counting the long bolt that also
> secures the clutch slave. So far I count two (2) at the top, two (2) one
the
> left side, one (1) on the right side above the starter and three (3)
smaller
> ones (two at the bottom, one on the left side) securing the lower sheet
> metal filler to the bellhousing  Am I missing any? I just want to make
sure
> before I get out the BFH and prybars! (Just kidding :<)) The transaxle
does
> not want to break loose. Also, what is the approximate balance point for
> lifting the trans and bellhousing? Is it about at the axle centerline or
> slightly ahead or behind it (and how far)? All the other disconnections
have
> been made and fortunately I have socket head allen bolts instead of studs
> holding the mounts to the trans sides. Thanks in advance for any and all
> advise.
>
> Doug Kelm
>
> Yellow '72 Pre-L #2886
>